PRINT ON FILM. Insert DTF transfer film in paper tray, platen, or on paper roll holder. Transfers for dark garments will require a white layer of ink over the mirrored color print.

POWER APPLICATION. Sprinkle the TPU powder uniformly over the wet print manually or using the automated commercial shaker. Remove excess powder.

MELT POWDER (1st Option). Place the powdered film inside a Curing Oven & heat for 2-3 min at 100-120°C.

(2nd Option). Hover film inside heat press (4-7 mm), powdered-side UP. DO NOT apply pressure Heat for 3-5 min at 140-150°C. DO NOT completely close the press! Wait until powder becomes glossy.

PRE-PRESSING.

Pre-press the garment prior to the transfer for 2-5 seconds This will flatten the fabric & remove excess humidity.

TRANSFER.

Place the film (print-side DOWN) onto the platen-threaded garment. Cover with silicone pad or parchment paper. Press for 10-20 sec at 325°F

COLD PEEL.

Allow the garment to completely cool. Peel the film off in one low, slow, continuous motion.

REPRESSING.

Re-press the garment for 10-20 sec at 325°F This step is recommended for increased durability